How to use Bypass Loppers correctly to avoid damaging the blade or branches?

Bypass Loppers are best suited for pruning fresh, resilient live branches. Such cuts will be smoother and help plants heal quickly. When pruning, avoid using it to prune hard or completely dry branches. Such materials may damage the blade. It is recommended to use chopping board pruning shears or hand saws instead. In addition, pay special attention to the diameter of the branch to ensure that it does not exceed the maximum shearing capacity of 32 mm specified by the product, otherwise it may cause the blade to break or the handle to deform, affecting the service life of the tool.

When using Bypass Loppers, a scientific grip should be adopted: four fingers naturally hold the lower handle, the thumb lightly touches the upper handle, and the wrist and arm are kept in a straight line. When cutting, it mainly relies on the strength of the arm, rather than simply relying on the wrist to exert force, which can reduce hand fatigue. In actual operation, the branch should be placed in the position where the blade is closest to the shaft. This is the part with the strongest leverage and the most labor-saving when cutting. When applying force, keep it even and slow, and avoid sudden and violent shearing, otherwise it may cause the blade to be dislocated or the branch to tear, affecting the pruning effect.

Professional pruning requires a 45-degree bevel cut, cutting at an angle about 0.5-1 cm above the bud point of the branch. This incision angle can effectively prevent rainwater accumulation and rot, while promoting rapid healing of the plant. Pay special attention to avoid two common mistakes: one is that the cut is too close to the bud point, which is easy to damage the new buds; the other is that the stump is too long, which not only affects the appearance, but also easily leads to dieback and mold growth.

To keep the blade in the best condition, wipe it with a soft cloth after each use to remove residual sap and debris to prevent corrosion. If stubborn resin adheres to the blade, it can be cleaned with alcohol or a mild detergent. It is recommended to apply special lubricating oil to the contact point between the shaft and the blade for maintenance after every 5-10 uses. Pay special attention to avoid using pruning shears to cut non-plant materials such as wire and plastic, and do not use a hammer to hit the blade to assist in cutting. These improper operations will cause irreversible damage to the tool.

When using pruning shears, you must take necessary safety precautions. It is recommended to wear non-slip gardening gloves to prevent your hands from slipping and being scratched by branches. When pruning high branches, pay special attention to prevent branches from rebounding to avoid hurting your face or eyes. If the blade is stuck, remember not to force it open. You should first gently shake the branch in the opposite direction and then slowly release the handle. If you really can't remove it, you can use a wooden stick to tap the back of the blade to help it disengage. Safe and standardized operation not only protects the user, but also prolongs the service life of the tool.